Aktobis WDH-200LS 빠른 시작 매뉴얼 - 페이지 6

{카테고리_이름} Aktobis WDH-200LS에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aktobis WDH-200LS 8 페이지. Radiant heater with led lamp

Instructions for use:

1. Commissioning

1.1. Insert the mains plug properly into the socket.

1.2. Switch the unit on at the main switch to readiness for operation. The unit then signals that it is

ready for operation by lighting up the main switch (see picture on the right) and the operating

light (lights up red).

1.3. By pressing the red operating light, you can switch the operation in the following sequence (circuit):

 Level 1 (1,000 Watt heating power)

 Level 2 (2,000 Watt heating power)

 Level 3 (No heating power, only LED lamp active)

 Level 4 (2,000 Watt heating power + LED lamp active)

 Off (No heating power, LED lamp not active)

2. Remote control

2.1. You can also control all settings and functions of your radiant heater with the remote control included in the

delivery. However, the main switch of the radiant heater must be switched on for this purpose. The remote

control requires two AAA (micro) batteries (not included) !

3. Cleaning & Storage

Always unplug the heater from the mains and allow it to cool down completely before cleaning it!

3.1. Cleaning:

Use a soft and damp cloth to clean the outside of the housing.

Only use mild cleaning agents to clean your radiant heater.

Also, make sure that no aggressive cleaning agents are used, they can damage your appliance !

Please make sure that no water gets inside your radiant heater at any time !

3.2. Storage:

We recommend that you repack the unit in its original box for storage.

Store the radiant heater in a dry and sufficiently ventilated place/space.

ON / OFF switch

Heating element 1

(1,000 Watt)

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de

> Operating light blue

> Blue operating light

> Operating light Red

ON / OFF switch

of the LED lamp

ON / OFF switch

Heating element 2

(1,000 Watt)