AeroBound AB01 사용자 설명서 - 페이지 5
{카테고리_이름} AeroBound AB01에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AeroBound AB01 11 페이지.
페이지 인쇄MONITOR ASSEMBLY INSTRUCTIONS
HALF LOGO WIDTH
Product logo
(A)
(A)
(A)
(A)
Fix the sensor to the central foot under
the handlebar, by loosening the screw
on the monitor holder enough to slide
25% Cyan
45% Cyan
75% Cyan
35% Black
0% Magenta
0% Magenta
0% Magenta
60% Yellow
100%Yellow
100%Yellow
0% Black
0% Black
0% Black
it over the foot. The sensor should be
approx. 2mm from the mat for the
most accurate readings.Tighten the
screw so it stays in place.
Place the battery into the back of the
monitor making sure that it is placed
the correct way round, as shown in the
battery well.
Slide the monitor attachment into the
back of the monitor and place onto
the sensor.
8
Connect the wire from the monitor to
the wire on the sensor.
RESISTANCE BAND INSTRUCTIONS
To attach the resistance bands,
remove the rubber feet from the two
side feet of the AeroBound, open up
the loop on the resistance band and
slide over the foot before attaching
the rubber foot back on.
MONITOR INSTRUCTIONS
COUNT:
Shows the amount of jumps
performed.
TIME:
Shows the length of time
exercising.
CAL:
Shows the amount of calories
burnt during exercise.
STRD/MIN:
Shows the amount of
jumps per minute you are performing.
SCAN:
Cycles through each mode
after a few seconds.
RESET:
Will clear any information
displayed on the monitor. Press this at
the start of each session.
MODE:
Allows you to cycle through
the different display functions.
The monitor requires one AAA battery
(not supplied). Remove battery when
not in daily use.
Dispose of old batteries safely.
The readings from the display
monitor may vary and are to be
used only as a guide
9