AerobTec Altis v4 사용자 설명서 - 페이지 13

{카테고리_이름} AerobTec Altis v4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AerobTec Altis v4 14 페이지. Recording/competition altimeter

Fig 13: Firmware update window

Note: there are two firmware types. One of them is marked, "F5J". This firmware complies exactly with

FAI F5J competition rules and no other options are allowed.

The Firmware marked, "Standard" allows more setting changes, including settings for F5J competitions. It

is recommended to use this firmware type during training and ordinary flights. However, this firmware type

is not allowed for use in certain competitions. It should be specified by the organizer of the competition,

which firmware is allowed.

If the firmware updates fails or if the process is interrupted, the device tries to update the firmware again

until it is successful. Once finished, your Altis v4 appears in the computer as a USB removable device

again.

If this does not happen or if the first start of the new firmware is not performed from USB, a safety function

is activated and backup firmware is written to your Altis v4. Note there is no indication of this state on the

screen and the screen is blank.

In this case, follow the firmware update instructions to update a new, valid firmware.

It is not recommended to supply your whole aircraft via the Altis v4 device, however it is possible. The best

choice is to use an external BEC circuit or separate power supply.

When manipulating the device and plugging or unplugging the device, do not push the display and the

area bellow it. It is recommended to hold Altis v4 on sides.

Do not mount the Altis v4 device on aircraft components which might be hot in operation (ESC, batteries)!

Do not touch the Altis v4 device to a metal surface, as this might lead to shorting of the power supply and

RC system may fail.

Do not put the Altis v4 in water, fuel or other liquids!

Before flying with the Altis v4 always perform a range check!

AerobTec Altis v4 User Manual