Akura AH260LCD 사용자 설명서 - 페이지 18
{카테고리_이름} Akura AH260LCD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Akura AH260LCD 19 페이지.
페이지 인쇄Appendix
Troubleshooting
Before calling a service technician, please check the following table for a possible cause of the problem and
some solutions.
Symptoms
TV will not turn on
No picture, no sound
No sound, picture OK
Poor sound, picture OK
Poor picture, sound OK
Unable to select a certain channel
Poor colour or no colour
The remote control does not operate
Disorder display at power on
Possible Solutions
Make sure the power cord is plugged in, then press [Power].
The remote control batteries may be dead. Replace the batteries.
Check if you have set the off timer.
Check the antenna/cable connections.
Press [Display] to see if you have select the right signal source.
The sound may be muted. Press
The station may have broadcast difficulties. Try another channel.
Check the speakers cable connections.
The station may have broadcast difficulties. Try another channel
Check the speakers cable connections.
Check the antenna connections.
The station may have broadcast difficulties. Try another channel.
Adjust the picture from the menu.
The channel may be skipped. See SKIP on page 9.
The station may have broadcast difficulties. Try another channel.
Adjust the SATURATION in the menu.
There may be an obstruction between the remote control and the
remote control sensor.
The batteries may be installed with a wrong polarity.
The remote control batteries may be dead. Replace the batteries.
Check if you have entered Teletext mode. Press [ Text ] to quit.
This may be caused by too short interval between power off and on.
Unplug the power and restart.
-15-
on the remote control or .
[
]
VOL+