Air Delights AutoFlush 설치 지침 - 페이지 3
{카테고리_이름} Air Delights AutoFlush에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Air Delights AutoFlush 4 페이지. For urinals & toilets
페이지 인쇄
VISUAL INDICATOR GUIDE
USER-IN-VIEW L.E.D. (Green light flashes 3 times, after
5 second delay, when a user is in view. The green light
flashes constantly when a user is in view during
the 7 minute start up sequence).
OBJECT LOCK SENSOR
BATTERY L.E.D. (Yellow light flashes
indicating it is time to replace
batteries with 4 new "C" batteries).
COURTESY MANUAL FLUSH BUTTON
(Allows manual activation of
flush when needed—Toilet
model only).
ADJUSTING YOUR AUTOFLUSH
-
-
+
-
+
+
Use battery compartment wrench to remove
battery compartment tray.
TO CHANGE ACTIVATION DISTANCE FOR THE OBJECT LOCK SENSOR:
1
Remove battery compartment tray as shown at left.
2
Remove cover and sensor adjustor tool as shown at left.
3
Replace battery compartment in AutoFlush to activate unit.
4
Press sensor range reset button shown on next page (the green L.E.D.will flash continuously when it has an object in
view for the seven minute reset period).
5
Stand at desired activation distance.
6
Use sensor adjuster tool and turn Distance Adjustment Screw all the way down and then turn slowly up until green
L.E.D. begins to flash.
7
Ensure Object Lock Sensor is not detecting stall door or wall by closing door, stepping out of sensor path and making
sure green L.E.D. is not flashing. If sensor locks onto door or wall, unit will not flush properly. Shorten activation distance.
8
Remove battery compartment, replace sensor adjustor tool and cover. Replace battery compartment tray to reactivate
AutoFlush unit.
9
After 7 minute start-up sequence, the green L.E.D. will flash only 3 times when a user is in view
(after a 5 second delay).
Pull cover off by rotating battery side forward
and out.
Sensor Adjustor Tool comes in a built in storage
pocket.Replace after use.