Door-Gard 232se 기능 및 프로그래밍 매뉴얼 - 페이지 2

{카테고리_이름} Door-Gard 232se에 대한 기능 및 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Door-Gard 232se 4 페이지. Self-contained access control systems keypad

페이지 인쇄

4. Press 7890#123456 * . If all 12 keypresses have

been verfied, the keypad will enter self test mode.

Either the LED's will flash or the sounder will beep 3

times,.then light or sound continuously for 3 seconds

(except on the mullion). If these responses do not

happen, try the test mode again and then call tech

support. Note: self test mode can be used when trou-

bleshooting a keypad in the field. If you do not get the

continuous light or sound then the memory has been

corrupt and should be re-programmed with the 46

command (see option #16).

5. Enter the master code of 1234 * . The relay will

energize. Refer to programming section to program

your keypad.

NOTE:

The keypad may be programmed in your shop or at the

installation site. Programmed information is stored in non-

volatile memory so it will not be lost if power is removed.

ACCESS CONTROL DEFAULTS

Door-Gard Self-Contained Access Control Systems

are designed for easy installation in a minimum

amount of time. The following defaults have been fac-

tory programmed.

Master Code (user 1)

Lock Release Relay will energize for 5 secs.

Keypad Active Output

Keypress Feedback

Propped door relay will energize after

Forced door relay will energize for

If defaults must be changed or additional functions

are desired, please refer to the PROGRAMMING

OPTIONS Chart after you are familiar with the

PROGRAMMING section.

PROGRAMMING

1. Enter programming mode

Press 99 # (master code) *

1234 *

Off

30 secs.

10 secs.

Yellow LED

Flashes slow-

2. To Change master code

Press 1 # (new master code) *

Press (new master code) *

If main relay time must be changed,

substitute option 2 from Programming

Options chart for step 2 above.

3. To Add/change second code

Press 2 # (new user code) *

Press (new user code) *

4. To Add/change third code

Press 3 # (new user code) *

Press (new user code) *

5. Up to 120 codes may be added in this fashion

6. Exit programming mode

Press *

NOTE:

•

Door•Gard Self-Contained Access Control

Systems are factory programmed with a

master code of 1234 *.

•

Some Door•Gard products contain a sounder in

place of the yellow LED. In these products the

flashing is replaced by a beeping.

•

The master code is always user 1.

• The master code allows access to the

programming mode & activates the main relay.

• All codes must be followed by the *.

• Codes may be from 1-6 digits in length, and digits

may be repeated.

• If the master code is forgotten or does not seem to

be working, momentarily remove the programming

jumper (or push SW1 on the

diagram for location) to enter programming mode

and go to option #16 and default keypad.

• If the yellow LED lights (or sounder sounds) solid

while in programming mode an error has occurred.

Press * to clear (yellow LED should flash or sounder

sound) and start over from step 2 or 3 above.

PROGRAMMING OPTIONS CHART

If the pre-programmed default values must be changed

or additional functions are desired, the following

options may be programmed

Flashes fast

Flashes slowly

Flashes fast

Flashes slowly

Flashes fast

Flashes slowly

Out

style, see wiring