Ameristar MONTAGE Plus Classic 매뉴얼 - 페이지 3
{카테고리_이름} Ameristar MONTAGE Plus Classic에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ameristar MONTAGE Plus Classic 4 페이지. Ornamental steel fence
3-1 MARK LOCATIONS FOR ENDS, CORNERS & GATES
Using a string line, mark your property's boundary
lines. Based on your worksheet site plan, locate each
point where the fence starts, stops or turns a corner
(including points for gate locations) and mark it with a
stake (Figure 3-1).
Stake End, Corner & Gate Locations
When staking gate post locations, space the opening
between posts (inside post face to inside post face)
according to the following table:
Nominal
Nominal
3-2 MARK ALL REMAINING POST LOCATIONS
Starting at an end point, run a tape measure along the
ground to the next stopping point, and drive intermedi-
ate stakes at equal intervals of 96¾", plus or minus
½", to mark the locations for your remaining posts.
Note: All measurements must be made along the
ground elevation, regardless of slope. This ensures
the ATF (All Terrain Fence) feature is properly em-
ployed when panels are 'raked' to follow grade (see
Step 3-4).
4'
48-1/2"
8'
95"
www.MontageFence.com
Measure the distance between each end of the line;
drive a stake halfway between the ends. Proceed
from the center stake to the left end, staking every
96¾"; then return to center and repeat the process
as you move toward the right end (Figure 3-2).
Dig post holes at each marking stake (see Figure 3-3).
The exact diameter and depth of the hole may need
to be increased depending on local weather and soil
conditions. Regardless of depth of the hole, post height
(from ground line) should always be set as follows:
Line and corner posts will require four (4) universal
brackets; End posts will require two universal brackets.