AMERITRON AL-811H 소유자 매뉴얼 - 페이지 6

{카테고리_이름} AMERITRON AL-811H에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMERITRON AL-811H 19 페이지. Hf power linear amplifier
AMERITRON AL-811H에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지), 포장 풀기 사용 설명서 (11 페이지), 매뉴얼 (13 페이지)

페이지 인쇄
AMERITRON AL-811H 소유자 매뉴얼
Remove the screws and pull the rear panel off the shaft. Do not damage or rotate the blue plastic input switch
on the input circuit board. Once you have the panel back and off the shaft lay the panel down as in Fig. 6. You
can now remove the shaft from the chassis.
(Fig. 5)
To remove the tube chassis and work underneath it freely, the back panel must be dropped. Wiring in
amplifiers unfortunately is very inconsistent. Properly wired, the back panel will drop just like this, only
removing small screws in side rails and the rear bottom panel lip. This is a properly wired panel, which saves
you considerable time. Correctly wired panels have long transformer leads that allow rear panels to drop
without removing any wiring, with the exception of output coax:
(Fig. 6)
Note: Incorrectly wired panels will not drop without unsoldering multiple transformer wires, and perhaps coax
and other leads. It's advisable to take a picture of the panel with wires attached to aid in reassembly of the