Akva SUBSEA FEEDER 사용자 설명서 - 페이지 9

{카테고리_이름} Akva SUBSEA FEEDER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Akva SUBSEA FEEDER 20 페이지.

3 STORAGE AND TRANSPORTATION

WARNING

The AKVA Subsea Feeder must not be placed on the side before it has been

disassembled as described in this user manual. Laying the whole unit down on its

side will expose it to forces that may bend parts and render them unusable.

When transporting the AKVA Subsea Feeder over longer distances or when storing it in a location

with insufficient height to allow for it to stand upright, the feeder shall be divided it into 2 parts:

Top part including the cyclone, floating collar, main pipe and upper distribution chamber.

Bottom part including the sinker tube, branching pipes and lower distribution chamber.

The unit is divided by releasing bolts in the flange between distribution chamber and main pipe.

All parts of the AKVA Subsea Feeder can be stored outdoors, but the pump must be dismantled

and run in fresh water before storage for longer periods.

The top part can be laid down on deck or other surfaces, while the bottom must be upright on

the ground as shown in illustration 3:

Illustration 3:

Properly stored AKVA Subsea Feeder bottom part.

PROTECTIVE GEAR REQUIREMENTS

Wearing floating garments is mandatory when working on or by the sea.

After completing SJA, and if measures have been introduced for the transport to and

from the cage may be carried out in a safe manner, work can be commenced.

Provided that a crane that is long enough to lift the entire AKVA Subsea Feeder in a safe manner

is available, the AKVA Subsea Feeder may be loaded and unloaded using four lifting straps

attached to the main pipe as shown in illustration 4:

lifting.

Properly stored AKVA Subsea Feeder bottom

Lifting straps attached to main pipe for

DOCUMENT NO:

DOCUMENT PART:

DC10000901

10001800

part..

REVISION NO: