Canon PIXMA MX700 Series 서비스 매뉴얼 - 페이지 18
{카테고리_이름} Canon PIXMA MX700 Series에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX700 Series 44 페이지. Office all-in-one printer
Canon PIXMA MX700 Series에 대해서도 마찬가지입니다: 청소 매뉴얼 (7 페이지), 네트워크 설정 매뉴얼 (32 페이지), 보충 설명서 (6 페이지), 설정 지침 (2 페이지), 브로셔 및 사양 (2 페이지), 기술 정보 (2 페이지)
페이지 인쇄
DF Base (QC2-6162)
Document pressure sheet
(QC2-4884)
Scanner unit (QM3-2672)
Timing slit strip film
(QC2-5687)
Timing slit disk film
(QC1-9597)
Print head (QY6-0070)
*1: General notes:
- Make sure that the flexible cables and wires in the harness are in the proper position and connected correctly.
See
3-2. Special Notes on Repair Servicing
- Do not drop the ferrite core, which may cause damage.
- Protect electrical parts from damage due to static electricity.
- Before removing a unit, after removing the power cord, allow the machine to sit for approx. 1 minute (for capacitor discharging
to protect the logic board ass'y from damages).
- Do not touch the timing slit strip film and timing slit disk film. No grease or abrasion is allowed.
- Protect the units from soiled with ink.
- Protect the housing from scratches.
- Exercise caution with the screws, as follows:
i. The screws of the paper feed motor may be loosened only at replacement of the paper feed motor unit (DO NOT
loosen them in other cases).
ii. The screws securing the carriage rail may be loosened only at replacement of the carriage unit. After carriage
unit replacement, print on thick paper to confirm that the distance between the print head and paper (between the
carriage rail and the platen) is correct, and that the print head does not contact the paper during printing. If the
print head contacts the paper, adjust the carriage rail position, while referring to
Carriage rail
adjustment.]
- Upon contact with the film,
wipe the film with ethanol.
- Confirm no grease is on the
film. (Wipe off any grease
thoroughly with ethanol.)
- Do not bend the film
or the Parts Catalog for details.
<3-1. Notes on Service Part Replacement>
At replacement:
1. Adjust the document pressure
sheet position.
[See
3-3. Adjustment /
Settings, (2) Carriage rail
adjustment, for details.]
After replacement:
1. Perform print head alignment
in the user mode.
After replacement:
1. Perform print head alignment
in the user mode.
16 / 41
- Service test print
- Service test print