Canon 2168B002 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} Canon 2168B002에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon 2168B002 16 페이지. Canon scanner quick start guide

페이지 인쇄

35mm Slides

Align the Film Guide's tab with the FILM symbol on the document glass of the scanner.

Place a slide or slides face down (correctly viewed from

below) in the Film Guide as shown in the diagram to the

right.

120 Format Films

Open the film holder on the film guide, place the film face

down and close the film holder.

Align the Film Guide's tab with the FILM symbol on the

document glass of the scanner.

• Leave a gap of 5 mm or greater between film

strips when placing two or more on the

document glass.

• Ensure that there is no gap between the

edge of the film and the film guide on the

side near the calibration slot.

Using a Film Retainer Sheet

Curled film strips can stick to the document glass

and cause a pattern of rings called Newton Rings to

appear on the scanned image. If this occurs, scan

using the supplied film retainer sheet as shown in

the diagram.

(A) Scan with the film retainer sheet inserted

beneath the film.

(B) If Newton Rings still appear after following

Instruction (A), turn the film strip over and place

it in the film holder with the film retainer sheet on

top so that the film edges are held down for

scanning. Then preview the image in ScanGear

and click the [Mirror] button to reverse the image

before initiating the final scan.

To avoid damaging the film, always place the

glossy side (the side without an illustration)

of the film retainer sheet against the film.

Close the document cover.

(A)

Film retainer

sheet

With its glossy side

facing upward, slip

the film retainer

sheet under the film.

(B)

Hold the film edges down

by placing the film

retainer sheet on top with

its glossy side facing

downward.

Scanning Film

Film Holder

120 Format Film