Astro Pneumatic Tool 3036 매뉴얼 - 페이지 3
{카테고리_이름} Astro Pneumatic Tool 3036에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astro Pneumatic Tool 3036 4 페이지. Air belt sander
페이지 인쇄Model:
The oil and water extractor should not be mounted on or near the air
compressor.
The temperature of air is greatly increased during compression. As the air
cools down to room temperature, in the air line, on its way to the Air Power
Tool, the moisture contained in it condenses. Thus, for maximum
effectiveness, the oil and water extractor should be mounted at some point
Pitch pipe back toward air receiver
Compressor unit
Drain
Daily
3036
SUGGESTED AIR LINE CONNECTION
PIPE SIZE, I.D. (Inches)
Air Flow
CFM
50
10
1/2"
20
3/4"
30
3/4"
40
1"
50
1"
70
1"
Oil and Water Extractor should be at least 25 ft. from the compressor. Further if possible.
Product Type:
AIR BELT SANDER (10 x 330MM)
in the air supply system where the temperature of the compressed air in the
line is likely to be lowest. Air lines must be properly drained daily. Each low
point in an air line acts as a water trap. Such points should be fitted with an
easily accessible drain. See diagram below. Pitch all air lines back towards
the compressor so that condensed moisture will flow back into the air
receiver where it can be drained off. Drain daily.
Install drain at
Length of Pipe (feet)
each low point
150
200
100
3/4"
3/4"
3/4"
3/4"
3/4"
1"
1"
3/4"
1"
1"
1"
1"
1"
1"
1-1/4"
1-1/4"
1"
25 FEET OR MORE
Page 3
Oil and Water
Extractor
Drain
Daily
Drain
Daily