Acer Aspire 6200 사용자 설명서 - 페이지 16

{카테고리_이름} Acer Aspire 6200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Acer Aspire 6200 29 페이지. Acer aspire 6200: user guide

페이지 인쇄

Adding Options

You can add hard drives, memory, expansion cards, and other

options to your Acer Aspire. For directions on upgrading and

how to disassemble the computer chassis, please refer to My

Connecting

Aspire Guide software.

USB Devices

You can find information regarding your motherboard jumper

settings by referring to the panel inside your Aspire chassis.

The Universal Serial Bus

Opening/Closing Your Aspire Microtower

(USB) on you Aspire

Caution! Always turn off your computer and unplug it before

allows for easy and conve-

opening the case. For more information on the complete sys-

nient expansion options.

tem shut-down, refer to "Turning Your Aspire On and Off" on

With it, installing devices

page 6.

such as digital cameras,

scanners, and joysticks is a

Removing the Cover Panel

breeze.

1 • Place the system on a flat surface.

Please refer to My Aspire

Guide software for com-

2 • Remove the four screws from the rear panel. Set the screws

plete descriptions and

aside. You will need them when replacing the cover.

question-and-answer trou-

bleshooting information

regarding USB devices.

to Your Aspire

3 • Push the cover slightly backward as shown in the following

figure.

4 • Lift up the cover.

Note: For directions on upgrading and assembly/disassembly of the

computer chassis, please refer to My Aspire Guide software.

Replacing the Cover Panel

After you install the system components into the housing, you

must replace the cover panel.

1 • Position the top cover on the housing, aligning the sides

with the rails.

2 • Slide the cover forward until it fits into place.

Electrostatic

Discharge

Precautions

Always observe the fol-

lowing electrostatic dis-

charge (ESD) precautions

before installing a system

component:

• ESD can cause permanent

damage to your computer.

• Do not remove a compo-

nent from its antistatic

packaging until you are

ready to install it.

• Wear a wrist grounding

strap before handling elec-

tronic components. Wrist

grounding straps are avail-

able at most electronic

component stores.

• At a minimum, keep a

hand in contact with the

metal system housing to

reduce the ESD effect.

Adding Options to you Aspire