Astronergy CHSM60M-HC 설치 매뉴얼 - 페이지 2

{카테고리_이름} Astronergy CHSM60M-HC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astronergy CHSM60M-HC 12 페이지. Crystalline silicon pv
Astronergy CHSM60M-HC에 대해서도 마찬가지입니다: 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (12 페이지), 설치 매뉴얼 (18 페이지), 설치 매뉴얼 (19 페이지), 매뉴얼 (19 페이지)

페이지 인쇄

1. Introduction

1.1 Purpose

This document provides detailed instructions and valuable safety information regarding the

installation, electrical connection, and maintenance of following Chint Solar Crystalline Photovoltaic

modules:

CHSM60M(BL)-HC(166) CHSM60M-HC(166)

All the instructions should be read and understood before installation. The installers should

be trained and conform to all safety precautions in this guide when installing the module. Keep

this guide in a safe place for further reference.

1.2 Limitation of Liability

Because the use of this manual and the conditions or methods of installation, operation, use

and maintenance of photovoltaic (PV) products are beyond Chint Solar's control, Chint Solar

does not afford the responsibility and expressly disclaims liability for loss, damage, or expense

arising out of or in any way connected with such installation, operation, use or maintenance.

Chint Solar reserves the right to change the manual without prior notice.

1.3 Precautions of Installation

1.3.1 Module's unpack and transfer

a) When the whole pallet of modules are delivered to the site and unloaded, make sure the

safety of the modules especially if they need to be lifted for roof projects. Put them into a

protective device and then lift it to the roof in case of bumping against the wall during the

lifting process.

b) Firstly, tear the stretch film, then move away the top cover after cutting off each module

packing strip while unpacking. Two operators work as a group, grasp the module frame

tightly in the same direction and take out the module one by one. It is a must that the

operators remove the adhesive tape of the fixed module one by one, rive one piece and

then take out one piece of module. We don't allow to tear off all the adhesive tape at one

time in to prevent the whole package from toppling over or falling down. The whole process

must be taken very gently. Don't collide with any hard objects or let any parts of the frame

touch and drag on the ground.

c) After unpacking the modules should be installed that day as far as possible. It's

recommended to take the right amount of modules according to the progress of the project

Chint Solar (Zhejiang) Co.,Ltd. | Add:1335 Bin´an Road, Binjiang District, Hangzhou | P.C: 310053

Tel: 0086-571-5603 1888 | Fax: 086-571-5603 2316 | Website: http://energy.chint.com/

CHSM72M-HC(166)