Asus A7V-VM 사용자 설명서 - 페이지 13
{카테고리_이름} Asus A7V-VM에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus A7V-VM 23 페이지. Athlon/duron microatx motherboard
Asus A7V-VM에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (22 페이지)
페이지 인쇄
- 1. Specifications
- 2. Hardware Setup
- 3. Layout Contents
- 4. Hardware Setup Procedure
- 5. Motherboard Settings
- 6. System Memory (DIMM)
- 7. General DIMM Notes
- 8. DIMM Memory Installation
- 9. Central Processing Unit (CPU)
- 10. Expansion Card Installation Procedure
- 11. Expansion Cards
- 12. Assigning Irqs for Expansion Cards
- 13. Standard Interrupt Assignments
- 14. Interrupt Request Table for this Motherboard
- 15. Accelerated Graphics Port
- 16. External Connectors
2. HARDWARE SETUP
2.8 External Connectors
WARNING!
Some pins are used for connectors or power sources. These are
clearly distinguished from jumpers in the Motherboard Layout. Placing jumper
caps over these connector pins will cause damage to your motherboard.
IMPORTANT:
Ribbon cables should always be connected with the red stripe to
Pin 1 on the connectors. Pin 1 is usually on the side closest to the power connec-
tor on hard drives and CD-ROM drives, but may be on the opposite side on
floppy disk drives. Check the connectors before installation because there may
be exceptions. IDE ribbon cables must be less than 46 cm (18 in.), with the
second drive connector no more than 15 cm (6 in.) from the first connector.
1) PS/2 Mouse Connector (6-pin PS2KBMS)
The system will direct IRQ12 to the PS/2 mouse if one is detected. If one is not
detected, expansion cards can use IRQ12. See PS/2 Mouse Function Control
in 4.4 Advanced Menu.
PS/2 Mouse (6-pin female)
2) PS/2 Keyboard Connector ( 6-pin PS2KBMS)
This connection is for a standard keyboard using an PS/2 plug (mini DIN). This
connector will not allow standard AT size (large DIN) keyboard plugs. You
may use a DIN to mini DIN adapter on standard AT keyboards.
PS/2 Keyboard (6-pin female)
ASUS A7V-VM User's Manual
13