Akytec MU110-24.6U 사용자 설명서 - 페이지 8

{카테고리_이름} Akytec MU110-24.6U에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Akytec MU110-24.6U 18 페이지. Analog output module 6 channel

페이지 인쇄

Configuration

Before starting

►

NOTICE

Before switching on, make sure that the device was stored at the specified ambi-

ent temperature (-20 ... +55 °C) for at least 30 minutes.

Parameters of the module can be read, edited and saved with "M110 Configurator"

software . The full list of parameters is shown in the Table 5.1.

To control the module via Modbus network refer section 6.3 "Modbus addressing"

The module should be configured first before operating in RS485 network.

Proceed as follows:

─

install the configuration software "M110 Configurator" on the PC

connect the module to the USB interface of the PC over RS485-USB interface

─

adapter IC4 (not included)

─

connect the power supply to the terminals 24V / 0V

─

turn on the device

─

start the M110 Configurator

If the factory settings of the module have not been changed, the connection to the mod-

ule is automatically established, the module automatically recognized, its configuration

parameters read out and an appropriate configuration mask open.

If it does not happen, parameters of the configurator should be changed.

Table 5.1 Configuration parameters

Name

dev

bPS

LEn

PrtY

Sbit

akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany Tel.: +49 (0) 511 16 59 672-0 · www.akytec.de

Parameter

Device

ver

Firmware version

Baud rate, kbit/s

Data bits *

Parity *

Stop bits *

Valid value

Basic parameters

up to 8 characters

Network parameters

Meaning

Default

MU110-6U

manufacturer

2.4

4.8

9.6

14.4

19.2

9.6

28.8

38.4

57.6

115.2

none

even

none

odd