AL Guardian G9 RX 사용자 설명서 - 페이지 11

{카테고리_이름} AL Guardian G9 RX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AL Guardian G9 RX 20 페이지.

CONTROL BOX

The Control Box is to be mounted in the interior of the vehicle at the place of your choice and it should not

be exposed to water.

Locate access to the power supply of the vehicle (+12 V)

Connect the

RED

ground lead or the car chassis. If using the supplied wire taps (to be used only on a wire of the

appropriate size) insure that they are properly locked and preferably wrap them with insulation tape

afterwards.

To avoid the possibility of draining your car battery by accidentally leaving your AL G9

system on for prolonged time, use the following connection method instead of the one

described above:

Connect the BLACK Control Box wire to the car chassis or to the negative ground power

supply wire of your vehicle's system and connect the

positive power supply wire usually found in the car radio power supply.

After the control box is connected to the battery, connect the sensor into one of the S sockets. If having

more than 1 sensor connect all of them, their order is not relevant.

(1A fuse is factory installed inside the Control Box but if required additional fuses can be installed externally in the

wiring.)

CONTROL SET

Define where to install each control in the vehicle interior while keeping in mind that the on&off switch

and programming key button should be close

at hand and that the two-color light diode is in

sight while the speaker should remain within

hearing

range of the driver. Use a LED holder

supplied with the installation accessories

when installing a two color LED diode.

Connect the C connector to the C socket of the Control Box.

Connect the blue car radio mute wire to the corresponding audio mute input on the car radio, if it has

one.

Control Box wire to the positive battery lead and

BLACK

RED

Control Box wire to the SWITCHED

OPTIONAL: If using a Control

Set in a Box instead of

i n s t a l l i n g e a c h c o n t r o l

separately mount the box in a

clearly seen position.

AL G9 User Guide

Control Box wire to the