AL Guardian G9 RX 사용자 설명서 - 페이지 13

{카테고리_이름} AL Guardian G9 RX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AL Guardian G9 RX 20 페이지.

4. Usage

Turn on your AL G9 set. The activation is followed by an intermittent sound coming from the speaker and

alternating red and green flashing diode lights. While active the green light will flash once every second.

With every activation the set runs a self-test; if the set has not been connected properly or has a

malfunction, the red diode will light up accompanied by a warning tone. When an obstacle is detected your

AL G9 will warn you with red diode flashes and audible signals that will become faster as the obstacle gets

closer to the outer sensor. You will also be warned with fast red flashes and speaker tones in case of laser

interference detection. More on operation modes and audio-visual signals can be found on page 14.

AL G9 has 6 user selectable operating modes which are set to optimal default values but can be modified

by using the programming key button at any time during the operation of AL G9. After been modified

operating mode will remain permanently written in the memory of the processor. Some additional features

will be introduces further on.

4.1.1 Detection range adjustment (DEFAULT: LEVEL 2)

Before using the parking sensor in driving conditions it should be tested with a piece of paper or another

object. A warning tone will be heard, accompanied by the red flashing light as you bring the paper or object

closer to the sensor. If needed, the detection range (which can vary from 0 to 3 meters) can be adjusted to

four different levels by using the programming key button. Use the following sequence for reprogramming:

Press and hold the key button while counting the flashing green light.

Release the key button after the third (3) flash.

AL G9 will reprogram accompanied by red and green flashing lights and speaker tones. Long

tones coming from the speaker during reprogramming symbolize four different detection levels:

1 tone for LEVEL 1 (short mode);

2 tones for LEVEL 2 (medium mode);

3 tones for LEVEL 3 (long mode);

4 tones for LEVEL 4 (extra long mode).

The detection range levels alternate and you will need to reprogram the set several times before reaching

the desired setting.

9 AL G9 User Guide