Baumer GXP5W 매뉴얼 - 페이지 40

{카테고리_이름} Baumer GXP5W에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer GXP5W 41 페이지. Absolute encoder with canopen lift protocol
Baumer GXP5W에 대해서도 마찬가지입니다: 조립 지침 (2 페이지)

페이지 인쇄
Baumer GXP5W 매뉴얼

6. Connection Assignment and Commissioning

6.1. Mechanical attachment

Shaft encoder
• Mount the encoder housing on the flange mounting holes with three screws (square flange with 4 screws).
Observe the thread diameter and thread depth.
• As an alternative the encoder can be mounted in any angled position with eccentric mountings, see
Accessories.
• Connect the drive shaft and encoder shaft via a suitable coupling. The shaft ends may not touch each
other. The coupling must compensate shifting caused by temperature and mechanical play. Observe the
permissible axial or radial axis load. For suitable connections, see Accessories.
• Firmly tighten the mounting screws.

6.2. Electrical connection

6.2.1. Description of connections

Pin
Assignment
CAN_L
CAN Bus Signal (dominant Low)
CAN_H
CAN Bus Signal (dominant High)
UB
Supply voltage 10 - 30 VDC
GND B
Ground connection for UB
CAN_GND
Optional GND reference for CAN interface

6.2.2. Connection assignment of M12 plug

Pin
Assignment
1
GND B
2
UB
3
CAN_GND
4
CAN_H
5
CAN_L
3
4
5
2
1
Manual_GXP5_417_Lift_EN.doc
04.05.11
40/41
Baumer IVO GmbH & Co. KG
Villingen-Schwenningen, Germany