Baumer HUBNER BERLIN MHGE 100-HDmag 설치 및 작동 지침 - 페이지 20
{카테고리_이름} Baumer HUBNER BERLIN MHGE 100-HDmag에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer HUBNER BERLIN MHGE 100-HDmag 28 페이지. Encoder without bearings - incremental
Baumer HUBNER BERLIN MHGE 100-HDmag에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지)
페이지 인쇄
6
4
Montage / Mounting
Elektrischer Anschluss / Electrical connection
6.4
Ausgangssignale
6.4.2
Mit SinCos-Signalen:
(SN.... C)
Signalfolge bei
positiver Drehrichtung,
siehe Abschnitt 5.
Sequence for positive
rotating direction,
see section 5.
6.5
Sensorkabel HEK 8 (Zubehör)
Es wird empfohlen, das Baumer Hübner
Sensorkabel HEK 8 zu verwenden oder
ersatzweise ein geschirmtes, paarig ver-
seiltes Kabel. Das Kabel sollte in einem
Stück und getrennt von Stromkabeln
verlegt werden.
Kabelabschluss:
1...3 kΩ für:
HN, UN bei +UB = 10...30 VDC
120 Ω für:
RN, TN, SN, UN bei +UB = 5 VDC
Rot / Red = +UB
Blau / Blue =
Weiß / White = A+
Braun / Brown = A−
Grün /Green = B+
Gelb/ Yellow = B−
Grau /Grey = R+
Rosa / Pink = R−
Schwarz / Black = ---
Violett / Violet = ---
17
2.5 V
A+
360°el.
90°el.
360°el.
Baumer_MHGP100-T1_DE_EN_202210_MI_11121634 (22A1)
6.4
Output signals
6.4.2
With SinCos signals:
(SN.... C)
0.5 V
A−
1 V
[A+] − [A−] = Cos
1 V
[B+] − [B−]
[R+] − [R−]
>0.4 V
6.5
Sensor cable HEK 8 (accessory)
Baumer Hübner sensor cable HEK 8 is
recommended. As a substitute a shielded
twisted pair cable should be used.
Continuous wiring without any splices or
couplings should be used. Separate signal
cables from power cables.
Cable terminating resistance:
1...3 kΩ for:
HN, UN at +UB = 10...30 VDC
120 Ω for:
RN, TN, SN, UN at +UB = 5 VDC
Aderendhülsen benutzen.
Use core-end ferrules.
Kabelschirm
Cable shield
= Sin
MB210T1 - 11121634