Baumer POG 10 설치 및 작동 지침 - 페이지 27
{카테고리_이름} Baumer POG 10에 대한 설치 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Baumer POG 10 36 페이지. Incremental encoder twin encoder with harting connector
Baumer POG 10에 대해서도 마찬가지입니다: 설치 및 작동 지침 (32 페이지)
페이지 인쇄
7.5
Option Heizung: Stromanschluss für
Heizung
Kabellänge / Cable length ~1 m
7.6
Sensorkabel HEK 8 (Zubehör)
Es wird empfohlen, das Baumer Hübner
Sensorkabel HEK 8 zu verwenden oder
ersatzweise ein geschirmtes, paarig ver-
seiltes Kabel. Das Kabel sollte in einem
Stück und getrennt von Stromkabeln
verlegt werden.
Kabelabschluss:
HTL: 1...3 kΩ
TTL: 120 Ω
Rot/Red = +UB
Blau/Blue = 0V ( )
Weiß/White = K1
Braun/Brown = K1
Grün/Green = K2
Gelb/Yellow = K2
Grau/Grey = K0
Rosa/Pink = K0
Schwarz/Black = Err
Violett/Violet = 0V ( )
Option EMS
3)
MB069T1 - 11055669
3)
3)
Baumer_POG10-POG10G-T1_II_DE-EN (20A2)
Elektrischer Anschluss / Electrical connection
7.5
Option heating: Power supply for heat-
ing
24 V = /~
P
= 6 W
max
7.6
Sensor cable HEK 8 (accessory)
Baumer Hübner sensor cable HEK 8 is
recommended. As a substitute a shielded
twisted pair cable should be used.
Continuous wiring without any splices or
couplings should be used. Separate signal
cables from power cables.
Cable terminating resistance:
HTL: 1...3 kΩ
TTL: 120 Ω
Aderendhülsen benutzen.
Use core-end ferrules.
Kabelschirm
Cable shield
7
24