Asus AP6000 하드웨어 참조 매뉴얼 - 페이지 15

{카테고리_이름} Asus AP6000에 대한 하드웨어 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus AP6000 32 페이지. Dual pentium® ii server

II. System Components

Circulation System

The server's air circulation system is comprised of five 3 inch (8 cm) fans

mounted on a metal fan module. The circulation system cools the hard disk

drives by bringing fresh air in from the front and forcing the hot air out

through the back. It is important to keep the air surrounding the hard disk

drives below 122˚F (50˚C) to prevent hard disk failures.

The fan module can be removed by pulling the handle and inserted by push-

ing. The handle must be in the out position to insert the fan module. The

individual fans are secured by two clips and two hooks. To release these clips,

use a screw driver to push these clips in and then slide the fan out. If an

individual fan fails, remove the fan and send it back to the vendor for replace-

ment. If all five fans fail, it may be that the fan control board needs replacing,

remove the control board and send it back to your vendor for replacement.

Fan Module

Release Handle

Removing or inserting the fan module

Fan 1

Fan 2

Release Handle

(from chassis)

Fan 3

Fan 4

Fan Module

Control Board

Fan 5

Fan module

AP6000 Hardware Reference Guide

Air Inlet Vents (along

full length of door)

When replacing fans, be sure

that the fan rotations are in the

same direction. Use the

manufacturer's sticker on one

side of the fan as a reference as

to the side. Air flows from the

front of the server to the rear.

Fan Replacement (Reverse side)