Follett H50R5A/W 작동, 서비스 및 부품 설명서 - 페이지 4

{카테고리_이름} Follett H50R5A/W에 대한 작동, 서비스 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Follett H50R5A/W 17 페이지. Ice and water dispenser
Follett H50R5A/W에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)

페이지 인쇄

4. Remove dispense mechanism.

5. Wipe lid, wheel, baffle, inside of storage area and dispense mechanism with damp cloth wrung out in Solution A.

To avoid possible damage to motor assembly, use a damp cloth only. Do not allow water to

run through center hole in bottom of bin area.

6. Rinse all above items with damp cloth rinsed and wrung out in clear water.

7. Sanitize all above items with damp cloth wrung out in Solution B. Do not rinse.

8. Pour 1 cup (284ml) household bleach into drain pan, followed by 1 gallon (3.8L) of hot tap water to flush drains.

9. See Dispense Wheel Removal section for proper spacing of baffle and reinstall parts.

10. If unit is equipped with chilled water accessory, also see below.

If dispenser is equipped with chilled water accessory:

1. Remove two (2) screws securing splash panel and lay splash panel on dispenser drain pan.

2. Disconnect 3/4" drain line from bottom of chilled water canister.

3. Loosen (do not remove) screw securing front bracket of chilled water canister to bottom of dispenser hopper.

4. Rotate canister to left to release front bracket, then pull canister forward to disengage rear bracket.

5. Remove chilled water coil from canister and clean with cloth wrung out in Solution A.

6. Wipe inside of chilled water canister with cloth wrung out in Solution A.

7. Rinse all above items with damp cloth wrung out in clear water.

8. Sanitize all above items with damp cloth wrung out in Solution B. Do not rinse.

9. Reinstall chilled water coil into canister (rubber alignment grommet on coil tubing must be located outside chilled

water canister to hold coil securely against canister wall).

10. Reinstall chilled water assembly on dispenser and tighten screw securing front bracket.

11. Reconnect 3/4" drain line to chilled water canister.

12. Reinstall splash panel and top front cover.

13. Restore power and test operation.

Quarterly cleaning of icemaker system

Units with icemakers require icemaker cleaning at least every 3 months, and more often if local water conditions

dictate. Failure to clean icemaker will result in decreased performance and potential damage to icemaker. Refer to

Icemaker Operation and Service Manual for specific cleaning instructions.

Troubleshooting

Disconnect power to dispenser and icemaker before putting hands or arms in storage area

or attempting any repair or service to equipment.

Before calling for service:

• Check that there is ice in dispenser bin area

• Check that congealed cubes are not causing a jam

Symptom

1. Does not dispense

ice

Possible cause

a. Power switch off or faulty.

b. Faulty dispense switch.

c. Wheel motor malfunction.

d. Drive chain off.

e. Sprocket key missing.

f. Faulty dispense solenoid.

Service

• Check that all switches and circuit breakers are on

• Check that all drains are clear

a. Check switch. Turn on or replace if faulty.

b. Replace switch.

c. Check motor and replace as required.

d. Reinstall chain.

e. Install key and tighten sprocket.

f. Check solenoid and replace if faulty.

Solution