ams AG AS3932 애플리케이션 노트 - 페이지 6
{카테고리_이름} ams AG AS3932에 대한 애플리케이션 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. ams AG AS3932 8 페이지. 3d low frequency wakeup receiver
페이지 인쇄Application Note AS3932 - Migration from ATA5283 (1-channel) to AS3932
2.3
Serial Digital Interface
The AS3932 has a 4-wire serial data interface (CS, SDI, SDO, SCL) while the ATA5283 has no interface,
since no programmability is allowed. The Serial Digital Interface of AS3932 needs to be programmed accordingly
(see p. 16 to p. 18 of AS3932 data sheet).
2.4
Wakeup and data pin
Both AS3932 and ATA5283 have two dedicated pins for the wakeup and data; the only difference is that the
wakeup pin of ATA5283 (WAKEUP) has an inverted meaning compared to AS3932 (WAKEUP=high=no wakeup,
WAKEUP=low=wakeup)
2.5
Manchester clock recovery
Furthermore the AS3932 has a fully integrated Manchester clock recovery, which provides the recovered clock
on the pin CL_DAT. This pin is missing in the ATA5283, thus no clock recovery is possible. In case clock recovery
is not required, the pin CL_DAT of AS3932 can remain floating.
3
Protocol compatibility
The ATA5283 wakes up if a carrier burst of at least 704 periods is followed by a "start gap" (no Signal); an
example is given in the figure 3-1.
Figure 3-1: ATA5283 wakeup protocol description
In order to have full compatibility to ATA5283, AS3932 should be set to frequency detection only (R1<1>=0). In
this way the AS3932 will react to the presence of the carrier signal (WAKE signal goes high as soon as the carrier
Version 1.0, Date: 20/02/2009
Page 5 of 7