AmScope B270 매뉴얼 - 페이지 11

{카테고리_이름} AmScope B270에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AmScope B270 20 페이지.

B 2 7 0 User Gui de

1.4 Specimen Stage

The stage has an adjustable height limit. This is used to prevent the stage from being raised too high which could result in

damaging the specimen or even the objective lenses. The adjustment screw is located on the body just behind the stage.

Rotate the objective turret until the 100X objective lens is in place. With a specimen mounted on the stage, slowly raise

the stage using the coarse-focus knob until the specimen is a few millimeters from the lens. Use the fine-focus knob to

continue raising the stage until the specimen barely comes in contact with the lens. The 100X lens has a spring-loaded

nose. If the nose begins to compress, the stage is too high. When the specimen is able to make contact with the lens

without compressing the nose, this is the appropriate maximum height. The height-adjustment screw should be tight-

ened to set the stopping position. If the specimen was too far from the lens, and could not make contact, loosen the

adjustment screw slightly, then continue to make fine focus adjustments until the specimen is high enough. Once the

height is properly set, tighten the adjustment screw.

amscope.com