Electrolux 240400112EN 사용 및 관리 매뉴얼 - 페이지 6

{카테고리_이름} Electrolux 240400112EN에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux 240400112EN 22 페이지. Top mount refrigerator

Door Removal and Reversal Instructions

DOOR REMOVAL AND REVERSAL INSTRUCTIONS:

NOTE: If you have stainless steel doors -- go to the Removing Stainless

Steel Doors and Handles Section on page 9.

NOTE: The direction in which your refrigerator doors open (door swing)

can be reversed, from left to right or right to left, by moving the door

hinges from one side to the other. Reversing the door swing should be

performed by a qualified person.

IMPORTANT: Before you begin, turn the refrigerator temperature control

to "0" and remove the electrical power cord from the wall outlet. Remove

any food from door shelves.

1. Remove toe grille and top hinge cover.

2. Remove top hinge with 3/8" hex driver and lift freezer door off of

center hinge pin. Set door aside.

3. Unscrew center hinge pin using adjustable wrench and save for

reassembly. Ensure plastic washer stays on hinge pin.

4. Lift refrigerator door off of bottom hinge and set aside.

5. Remove center hinge and shim by removing inside screw and

loosening two outside screws enough to allow hinge and shim to

slide out. Tighten screws.

6. Loosen two outside screws on opposite side of refrigerator, remove

inside screw and install center hinge.

Remove two screws on bottom hinge with 3/8" socket wrench.

Install bottom hinge on opposite side with the two screws removed

from step 7.

9. Unscrew bottom hinge pin using adjustable wrench. Move hinge pin

to other hole in hinge and tighten with adjustable wrench.

10. Reverse door handles (see instructions on next page).

11. Move freezer and refrigerator door stops to opposite side. Before

starting screws, use an awl to puncture the foam.

12. Position refrigerator door onto bottom hinge pin and screw center

hinge pin through center hinge into top of door. Close refrigerator door

to help align hinge hole.

13. Tighten center hinge pin with adjustable wrench.

14. Remove cabinet and hinge hole plugs and move to opposite side.

15. Lower freezer door onto center hinge pin.

16. Close freezer door. Have an assistant lift up on opposite side of door

while tightening screws to install top hinge.

17. Replace toe grille and top hinge cover.

18. Plug in electrical power cord and turn refrigerator temperature control

to center position. Adjust setting as necessary.