Bosch Evolution HDS7052U 전환 매뉴얼 - 페이지 6

{카테고리_이름} Bosch Evolution HDS7052U에 대한 전환 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Evolution HDS7052U 32 페이지. Dual fual ranges
Bosch Evolution HDS7052U에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (36 페이지)

페이지 인쇄

Conversion

Convert Cooktop Valves

for Propane Use

Adjust Broil Burner Ori-

fice

English 4

5. Place the new orifice into the socket then insert each orifice into its respective

threaded hole in the jet holder. Tighten until the orifice stops turning. DO NOT

OVER TIGHTEN.

6. Remove screws to replace burner base, burner cap and burner grate.

Replace screws.

Note: Burner cap must be properly positioned on burner base for burner to

light.

7. Place natural gas orifices in back of card for future conversion back to natural

gas.

1. Verify that all knobs are in the OFF position

2. Remove knobs (pull straight out)

3. Insert 1/8" (or smaller) flat head screwdriver into shaft and turn bypass screw

clockwise until it stops (bypass screw is inside shaft). DO NOT OVER-

TIGHTEN.

Bypass Screw Inside Shaft

5. Replace knobs.

If your range is dual fuel your conversion is complete. Replace the cover

plate and warming drawer and proceed to "Test the Installation" on page 6.

For gas range conversions, continue to next step.

1. Remove oven door (see section "Removing Oven Door" in Use and Care

manual).

2. Remove Broil Burner Assembly. The broil burner assembly is attached to the

top of the oven cavity with 7 screws. Remove screws and gently pull broil

burner assembly straight out being careful not to detach electrical wires.

Place broil burner against back wall of oven cavity.

3. Adjust Broil Orifice. The orifice is located behind the broil burner in the back

oven wall (See Figure 5). Use a 1/2" deep socket driver with 3" minimum

Figure 4: Cooktop Valve Conversion