Bosch 0 986 612 997 사용 설명서 - 페이지 12

{카테고리_이름} Bosch 0 986 612 997에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch 0 986 612 997 44 페이지.

12. Pressing-in procedure

12.1 Preparation

The pressing-in procedure is described here by way of an example and applies similarly

for other pressing-in tasks.

Mount the component (e.g. flange) together with the part to

be pressed in (e.g. bushing, shaft sealing ring) and the

press-in tool on the force-measurement device

0 986 612 878.

Important!

Before switching on the manual indicator ensure that the force

pickup is connected to the manual indicator.

Switch on the manual indicator using the On/Off switch (1) on

top of the device.

Firstly, all the characters on the display are shown and then the

program version.

Ignore the displayed numerical value.

12.2 Sequence

Press the tare key [ T ] as often as it takes until the light emitting diode

[ Tara ] goes on and the display shows [ 000.0 ].

(000.0 = 000.0 kN)

Press the peak value key [ S ] once.

The light emitting diode [ MAX ] goes on.

The display must show [ 000.0 ].

If the display shows a value other than [ 000.0 ], press the mode key

[ MODE ] once.

This causes the peak value function memory to be deleted and [ 000.0 ] is

shown in the display.