Alen MPF-12CR 소유자 매뉴얼 - 페이지 14
{카테고리_이름} Alen MPF-12CR에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alen MPF-12CR 17 페이지. Portable air conditioner
Alen MPF-12CR에 대해서도 마찬가지입니다: 소유자 매뉴얼 (15 페이지)
페이지 인쇄
Names and Functions of indicators on Remote Controller
TRANSMISSION Indicator: This indicator lights when remote controller
1
transmits signals to indoor unit.
MODE Display: Shows the current operation modes-- AUTO, COOL,
2
DRY , HEAT and FAN. HEAT only available for heat pump model.
HEAT PUMP ONLY - LOCK display is displayed by pushing the
3
LOCK button. Push the LOCK button again to clear display.
TIMER Display: This display area shows the settings of TIMER. That is,
4
if only the starting time of operation is set, it will display the TIMER ON.
If only the turning off time of operation is set, it will display the TIMER OFF.
If both operations are set, it will show TIMER ON OFF which indicates you
have chosen to set both the starting time and off time.
FAN Display: When the FAN button is pushed, this signal indicator lights.
5
Digital Display Area: This area will show the temperature and, if in the TIMER mode,
6
will show the ON and OFF settings of the TIMER.
NOTE: All items are shown in the Fig.2 for the purpose of clear presentation But during the actual operation
only the relative functional items are shown on the display panel.
Operating of the Remote Controller
Install / Replace Batteries
The Remote Controller uses two alkaline dry batteries(R03/Ir03X2).
1. To install batteries, slide back the cover of the battery compartment and install the batteries
according to the directions (+and -) shown on the Remote Controller.
2. To replace the old batteries , use the same method as mentioned above.
NOTE
1. When replacing batteries, do not use old batteries or a different type battery. This may cause the
remote controller to malfunction.
2. If you do not use the remote controller for several weeks remove the batteries. Otherwise battery
leakage may damage the remote controller.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no answering beep from the indoor unit or if the Transmission
Indicator light fails to appear.
AUTOMATIC OPERATION
When the Air Conditioner is ready for use, switch on the power and the OPERATION indicator lamp on the
display panel of the indoor unit starts flashing.
1. Use the MODE select button to select AUTO.
2. Push the TEMP button to set the desired room temperature. The most comfortable temperature settings
are between 21 C/70 F to 28 C/82 F
3. Push the ON/OFF button to start the air conditioner. The OPERATION lamp on the display panel of the
indoor unit lights. The operating mode of AUTO FAN SPEED is automatically set and there are no
indicators shown on the display panel of the remote controller.
4. Push the ON/OFF button again to stop the unit operation.
NOTE
1. In the AUTO mode, the air conditioner can logically choose the mode of COOL, FAN, HEAT and DRY by sensing
the difference between the actual ambient room temperature and the set temperature on the remote controller.
2. If the AUTO mode is not comfortable for you , the desired mode can be selected manually.
12
O
o
O
Display Panel
1
2
AUTO
COOL
DRY
HEAT
3
4
Fig. 2
6
5
FAN
HIGH
MED
LOW