Anchor Navi-Trac LT/CS 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Anchor Navi-Trac LT/CS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Anchor Navi-Trac LT/CS 16 페이지. Pavilion 12' to 24' projection
페이지 인쇄Point B
Point A
LAYOUT DIMENSIONS
Pavilion Size
"A" Dimension
12' Projection x 30'
12'-6 15/16"
14' Projection x 30'
14'-6 15/16"
16' Projection x 30'
16'-6 15/16"
18' Projection x 30'
18'-6 15/16"
20' Projection x 30'
20'-6 15/16"
22' Projection x 30'
22'-6 15/16"
24' Projection x 30'
24'-6 15/16"
To fi nd a diagonal measurement not listed here, use
this formula: width² + length² = diagonal²
Standard 4-hole Base Plate
PLAN VIEW OF 3 BAY STRUCTURE
C L Front and Back
Uprights
10'-0"
"B" Diagonal Dim.
32'-6 3/8"
33'-4 1/4"
34'-3 5/16"
35'-3 7/16"
36'-4 9/16"
37'-6 9/16"
38'-9 3/8"
(22' Projection shown)
BACK OF PAVILION
C L Uprights
FRONT OF PAVILION
10'-0"
30'-0"
Directions for Squaring the Tent
1. Locate the four primary corners.
a. Using a tape measure, mark Points A & B (the width of the pavil-
ion fi rst.
b. Using one tape measure, start from point B and measure the
length of the tent.
c. Using a second tape measure, start from point A and measure the
diagonal.
d. Mark the point at which these two tapes intersect. (Point C) This
will square the tent.
e. Using the same process, mark point D.
2-Hole Base Plate for End Uprights
C L Uprights
4-Hole base plate
(typ.)
10'-0"
(see the diagram above)
2. Locate points for inter-
mediate uprights.
sure running from points A
to B, mark for end uprights
(only on frames over 20'
projection).
b. Using a tape measure
running from points B to
C (or A to D) mark for side
uprights according to your
particular pavilion.
These markings will be
your guideline for tent
layout.
Point C
Upright centered on
end required only
on structures above
20' projection.
(2) Hole Base Plate
required at this
position only.
C L Front and Back
Uprights
Point D
a. Using a tape mea-
6