Andatech Sentry 사용자 설명서 - 페이지 5
{카테고리_이름} Andatech Sentry에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andatech Sentry 20 페이지. Baton breathalyzer
페이지 인쇄LED Light Options
1. Press and hold the left button
pressing to change the light colour.
2. Hold down the left button
Troubleshooting / Warning Display
Escape to "go" (ready to blow) mode from the setting menu.
Shortcut key: hold the
The unit is running out of batteries. Replace with new batteries now
(Replace all batteries at the same time. Do not mix old and new
batteries)
Appears when the surrounding temperature is below -5*C when it is too
low to operate the device.
Appears when the surrounding temperature is above 50*C when it is too
high to operate the device.
Number of DAYS before calibration is required. For example, d.30
means 30 days left before calibration is required.
Number of test COUNTS before calibration is required.
For example, t.99 means 990 test counts before calibration is required.
This warning will only appear before the warming up status when the
device is switched on.
Number of DAYS that the calibration grace period has been activated.
The CA.d and specific number of DAYS left until calibration lock will be
displayed alternatingly.
Device must be calibrated before this number counts down to zero.
Number of test COUNTS that the calibration grace period has been
activated.
The CA.t and specific number of test COUNTS left until calibration lock
will be displayed alternatingly.
(001 = 10 COUNTS left)
Device must be calibrated before this number counts down to zero.
to enter the LED light options. Continue
to revert to the default white LED light option.
buttons together
6