Andersen 3165-RDH 설치 매뉴얼 - 페이지 6
{카테고리_이름} Andersen 3165-RDH에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 3165-RDH 8 페이지. Ultimate connection gooseneck trailer
4-2.
Place the pin through the lower coupler sleeve under the
gooseneck ball and secure it in place with the hairpin clip. Push
the entire base forward towards the cab of the truck until it will
not go any further.
4-5. IMPORTANT Now RETIGHTEN the top bolt to 60 ft-lbs of
torque (see step 4-3 above). This takes up any extra slack from
the Ultimate base.
4-6.
Using a 15/16" socket wrench, tighten the two square
coupler set bolts to 60 ft-lbs of torque to take out any play in the
tube.
DONE. You are now ready to attach your 5th wheel trailer
to the base unit.
Once you have disengaged the Gooseneck Coupler tube and your trailer is out of the way, you can remove the base and
free up your truck bed by simply reversing the steps above as follows: Loosen the two coupler set bolts, loosen the
coupler top bolt and remove the pin from the square coupler tube.
Page of
6
8
• Andersen Ultimate Connection Gooseneck Trailer Mount Installation Manual 8-2017 • www.AndersenHitches.com
SECTION 4: INSTALLING THE BASE UNIT
Note: Before installation make sure that the gooseneck ball in the bed
of the truck is in the up position and locked into place.
4-3. Using a 15/16" socket
wrench, tighten the top bolt of
the square coupler to 50 ft-lbs of
torque. This will ensure that the
coupler is pulling up on the
gooseneck ball and holding the
Ultimate Connection firmly to
the bed of the truck.
4-4.
Line up the Gooseneck
Coupler tube above the Ultimate
Ball and place the full weight of
your trailer onto the ball. Secure
the Coupler Tube by using the
remote latch and then locking the
remote handle in place (see
previous page).
SECTION 5: REMOVING THE BASE UNIT
THERE IS NEVER A NEED TO GREASE BALL OR COUPLER
4-1. Place the Ultimate
Connection base in the
bed of your truck so that
the Ultimate Adjustable
Ball is closest to the
tailgate (as shown left).
S q u a r e u p t h e h i t c h
before tightening it down.
NOTE: