ATIGO A901S 설치 매뉴얼 - 페이지 2

{카테고리_이름} ATIGO A901S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATIGO A901S 5 페이지. 2 wire kit

Door entry panel A501S

Connection Terminal

L1 and L2 is bus line connecting to terminal

BUS(DS) on the power supply

LK+ and LK- is a lock/relay output, set by the

jumper.

JP lock power mode (internal/external power)

Specification:

Power supply: 26Vdc (supplied by A2100)

Power consumption: 14mA standby,

Camera: Colour CMOS, 2 Mega pixels,

1/2.7" Fisheye, 155º Wide angle.

Unlock power output: 12Vdc, 250mA

Unlock time: 3, 5 or 10 seconds

Working temperature: -15ºC ~ +55ºC

Installation: Surface mounting

Dimension: 160(H) x 60(W) x 31.5(D)mm

DIP switch settings for A501S

The video door entry panel is configured by 6

DIP switches.

The DIP switches can be modified either

before or after installation. Restarting the unit

is necessary whenever the DIP switches have

been modified.

DIP switches 1 and 2 are for door station

default ID setting and must be set as 00.

DIP switches 3 and 4 are for setting door

unlock time.

DIP switch 5 is for setting lock type:

Fail locked (normally closed)

OFF

Fail unlocked (normally open)

DIP switch 6 is for programming door entry

panel.

Programming mode enabled

OFF

Programming mode disabled

122mA active