Bosch WTA74202ID 설치 및 운영 지침 매뉴얼 - 페이지 34

{카테고리_이름} Bosch WTA74202ID에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch WTA74202ID 40 페이지.

페이지 인쇄

Faults and what to do about them

Faults

Drying time too long?

Condensation in the

exhaust air duct.

Displayed drying time

changes during drying

process.

Humidity in the room

increases.

One or more indicator

lights are flashing.

Power cut.

* depending on the model

If you cannot rectify the fault yourself by turning the dryer off and on, please

Note:

contact our after-sales service.

Cause/remedy

The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-

■

ter.

Unsuitable programme selected?

■

Dryer installed too closely to other objects? Provide adequate air circulation.

■

If the ambient temperature is higher than 35 °C, this may extend the drying

■

time.

Insufficient air circulation in the room may increase the drying time. Ventilate

■

the room.

Mains failure? Restart the dryer.

■

Exhaust air duct too long? Check the maximum exhaust air duct lenght. Futher

information ~ Page 15.

Not a fault. The moisture sensors detect the remaining moisture in load and cor-

rect the programme lenght (except timed programmes).

Not a fault. Make sure the room is sufficiently ventilated.

■

Exhaust air duct installed/the exhaust air routes directly into the open air?

■

~ Page 15

Clean the fluff filter ~ Page 29.

■

Check the installation condition ~ Page 14.

■

Exhaust air duct blocked or bent? Clean the exhaust air duct ~ Page 32.

■

Switch off, allow to cool, switch back on, and restart the programme.

■

The drying program is interrupted. Remove the laundry and spread it out, or

restart the program.

Note:

Be careful as the door , the drum and the laundry may be hot.