Dreamline ENIGMA-Z SHDR-62607610 Series 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Dreamline ENIGMA-Z SHDR-62607610 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dreamline ENIGMA-Z SHDR-62607610 Series 20 페이지. Shower door & tub door
1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece
count with your packing slip. After opening all boxes and packages read this introduction carefully.
Check that all of the needed parts are included in the package by checking off the components on the
"Detailed Diagram of Shower Door Components". If the unit has been damaged, has a finishing defect,
or has missing parts, please contact our customer support department within 3 business days of the
delivery date. Please note that DreamLine
parts free of charge after 3 business days or if the product has been installed. Feel free to contact
DreamLine
if you have any questions, and please provide an order number, job name or other proof
®
of purchase to help identify the original order.
2. Please note that you should consult your local building codes with questions on installation
compliance standards. Building and plumbing codes may vary by location, and DreamLine
responsible for code compliance standards for your project and will not accept any returns.
3. If this unit is going to be installed in new construction, please install all of the required plumbing and
drainage before installing the shower. Use a competent and licensed (if required by local code)
plumber for all plumbing installation.
4. Please make sure that prior to beginning the installation, the surfaces are leveled and solid and will
be able to support the total weight of the unit. Also make sure the walls are at right angles. Irregular
installation surface level, radius corners or improper angle of side walls will result in serious problems
for your installation. Please, note that some adjustments and drilling might be necessary during the
installation process.
5. Please protect all primary surfaces of the product during installation. Never set your glass down
directly onto a tile floor. Leave corner protectors in place until necessary to remove them. Always use a
piece of wood or cardboard to protect the bottom edge and corners of the glass prior to and during
installation.
6. This unit must be installed upon a finished threshold and against finished walls.
7. This model has NO adjustment for out-of-plumb wall conditions. Verify that your walls are plumb
before proceeding with the installation.
8. This model requires that you drill into the threshold for proper installation.
9. Take extra care during installation when you set your glass directly onto the threshold as instructed.
10. This door requires a minimum 2-3/8"of flat threshold space for installation.
Please note that step #9 calls for installation of the door to the wall using anchors.
However, the manufacturer strongly recommends installing these heavy doors to the studs or to
pre-installed 2x6" wood reinforcements behind the wall.
Attention: This door is extremely heavy and requires professional installation and 2 installers.
NOTE: The Enigma Series doors and enclosures are reversible for left or right-hand installation.
This manual will show the right-hand door installation. For a left-hand installation, simply begin
on the opposite wall and reverse the orientation of the parts as necessary. Shower height model
shown. Tub height installation follows the same steps.
ENIGMA-Z manual Ver 1 Rev 4 10/2016
Preparation
will not replace any damaged products or missing
®
is not
®
5