DREAMS DAWSON OTTOMAN SOUND BED with O.S.B. 조립 지침 매뉴얼 - 페이지 13

{카테고리_이름} DREAMS DAWSON OTTOMAN SOUND BED with O.S.B.에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DREAMS DAWSON OTTOMAN SOUND BED with O.S.B. 18 페이지. Single size

페이지 인쇄

Fit the mattress stopper (H).

Unpack the contents of the Ottoman Support Bar

(O.S.B.) from it's carton - this is packed inside Pack 3.

To underneath of the slat frame, fit the parking

bracket (P). This is used to safely keep the

support bar out of the way when not in use. Use

one bolt set (m, b & c) - please make sure the

bracket is fitted the correct way round as

shown. Screw into the threaded insert on the

underside of the frame.

To underneath of the slat frame, fit

ii)

the O.S.B. support bar (M) as shown.

Using two bolt sets (m, b & c), screw

the bolts into into the threaded inserts

on the underside of the frame.

Please do tighten 100% yet.

iii)

Fit the fixed retaining bracket (N)

to the side rail using two bolt sets

(m, b, & c). Screw the bolts into

the threaded inserts on the side

rail. Make certain the bracket is

level and at the correct height.

Please do not tighten 100% yet.

100%

Dawson Ottoman Sound Bed - Assembly guide - Page 13

100%

i v)

The bolts should be in the centre of the

long holes and one may need to slide

the inner bar and the bracket, up or

down so the bottom of the O.S.B stem

90%

just touches the surface - better to do

this AFTER the mattress is fitted.

Push the mattress

stopper (H) into the end

of the metal slat frame,

the legs should go all the

way through the upper &

lower metal sections.