ANDI WMA 7612 L 분해 - 페이지 5

{카테고리_이름} ANDI WMA 7612 L에 대한 분해을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDI WMA 7612 L 14 페이지.

• Pull down the front panel and release from the fixtures on the body.

8- HINGE

• Remove the front door.

• Remove the bellow clamp that attaches the bellow to the front panel.

• Remove the bellow.

• Remove the two screws that connect the hinge to the front panel. ( Figure 1c )

9- LOWER COUNTER WEIGHT AND TUB COVER

• Remove the front panel. ( figure 3, 4, 5 )

• Remove the lower counter weight fixture screws and pull off the counter

weight.

• Tub cover is assembled with 12 clips to the tub. Remove them and take out

the tub cover.

10- TUB SEAL

• Remove the front panel. ( figure 3, 4, 5 )

• Remove the lower counterweight.

• Remove the tub cover.

• Tub cover is pulled off and turned upside down.

• Tub seal is removed. ( When remounting, the tub seal, assemblying mark on

tub should match the corresponding mark on the tub cover )

Figure 5