ANDIAMO 2007 Moorings Beneteau 32.2 운영 매뉴얼 - 페이지 11

{카테고리_이름} ANDIAMO 2007 Moorings Beneteau 32.2에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDIAMO 2007 Moorings Beneteau 32.2 18 페이지.

line. Release the boat hook. If your mooring line is led out the starboard cleat, bring the end of the line back

to the port side cleat. You will essentially create a bridle with about 10 feet of slack from the cleats to the

can.

ANCHORING

Andiamo carries a plow type anchor on the bow attached to 50 feet of chain and 200 feet of 5/8-inch rode.

There is a windlass which is controlled by a pendant in the forward cabin.

Setting the anchor:

Let out sufficient anchor rode (chain and line) before setting the anchor. Color markers are placed every 30

feet on the chain and nylon rode. If the anchorage is crowded, put down at least a 3 to 1 scope (60 feet of

rode for 20 feet of water at highest tide). Back the anchor in with a short burst in reverse from the engine.

Then let out additional scope dependent upon conditions. If the anchorage is less crowded, more scope is

always a better option. The holding power of the anchor increases greatly as more scope is added. There is a

second anchor in the starboard cockpit lazarette. This can be set off the bow or the stern as needed. Be sure

to secure the bitter end, as it is not secured in the lazarette.

Raising the anchor:

Coordinate the maneuver with the helmsperson to remain steady above the anchor as it is raised. As the

anchor rises, be careful not to allow it to swing against the hull.

Andiamo has two electrical systems, 110 volts AC and 12 volts

DC. It is important to understand these two systems are

completely separate and isolated from one another. There is no

inverter. Both AC and DC systems are controlled at the electrical

panel at the navigation station.

110-Volt AC System

Andiamo is equipped with the capacity to plug into dockside shore power (110 volt AC) using the heavy

yellow shore power cord. This system powers everything on the AC circuit breaker panel:

110 volt AC wall outlets

Battery charger

Water heater

Connecting to shore power:

Check the power rating/plug size of the nearest dock receptacle (that is 30 amps, 20 amps, or 15 amps). If

necessary, add a shore power cord adapter located in the compartment forward of the navigation station. The

procedure to hook up to shore power is as follows:

1. Make sure the "AC Main" circuit breaker is off.

2. Turn off the circuit breaker located at the shore side outlet on the dock.

3. Connect the plug to the shore side outlet. Give the plug a small twist clockwise to lock.

4. Turn on the circuit breaker at the dock.

PAGE 6