Atkinson Dynamics AD-28LD-MV 설치 및 서비스 지침 매뉴얼 - 페이지 8

{카테고리_이름} Atkinson Dynamics AD-28LD-MV에 대한 설치 및 서비스 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atkinson Dynamics AD-28LD-MV 16 페이지.

B. UNPACKING.

After unpacking the Model AD-28LD-MV, examine it for damage

that may have occurred in transit. If the equipment has been dam-

aged, do not attempt to install or operate it, file a claim immediately

with the carrier stating the extent of the damage. Carefully check all

envelopes, shipping labels and tags before removing or destroying

them.

Before attempting to install the intercom, be sure that all parts

listed in the KIT CONTENTS LIST have been supplied.

C. KIT CONTENTS LIST.

Qty.

Description

Instruction Manual

Resistor, 1 K, 1 W

D. MOUNTING.

The selection of the mounting location for the device, its con-

trols and the routing of the wiring is to be accomplished under

the direction of the facilities and the safety engineer.

The intercom is intended to be mounted on any relatively flat and

rigid surface by the four mounting holes in the interior of the housing.

Figure 4 is a dimensional outline drawing showing the proper mount-

ing configuration. The four mounting holes are 0.202 in diameter and

are designed to accept a #10 mounting screw. Hardware for mounting

the intercom to the surface is left up to the installer. The intercom

housing has two combination 1/2"-3/4" knockouts in the bottom. When

installing the conduit to these openings, choosing the size and type of

connector is left up to the installer.

E. ELECTRICAL CONNECTIONS.

Do not connect wires when power is applied.

The intercom has two wiring compartments, one for Class I wir-

ing and the second for Class II wiring. All wiring to the intercom is

terminated at two pc board mounted terminal blocks provided. The

AC Phase and Common, along with Earth Ground, are landed in a

Part Number

2562445

K101216

CAUTION

WARNING

-8-