Atkinson Electronics A0217 매뉴얼 - 페이지 14

{카테고리_이름} Atkinson Electronics A0217에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atkinson Electronics A0217 16 페이지. Generator start control module

Fuel Powered Pump

A pressure or level switch starts a direct engine driven pump similar to application 5. The K5 (load transfer) relay is used to

energize the pump unloader valve closing when the engine is running. The unloader valve bleeds off the pump pressure when

de-energized. The standard GSCM "out of the box" looks for a minimum 100V AC frequency input signal. Order a special low

voltage generator frequency input version for 12V alternator applications. GSCM, 12V ALT 255 Hz. See AUTOMATIC STARTING

FOR BATTERY CHARGING section: 9 & 4:9.

The room thermostat (should be line voltage slow action type to minimize short cycling) signals the generator to start. The

GSCM K5 (load transfer) relay starts the air conditioner after the generator is running. When the thermostat is satisfied, it

opens the start signal to the GSCM. The air conditioner is instantly turned off by the K5 (load transfer) relay, however, the

generator continues to run during the cool down cycle for the period of time selected.

www.atkinsonelectronics.com

800.261.3602

Circuit Board Division

Revised 09/18