ATL ATU Telex Unit 작동 및 설치 매뉴얼 - 페이지 14

{카테고리_이름} ATL ATU Telex Unit에 대한 작동 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATL ATU Telex Unit 16 페이지.

Display Complete Configuration (Y)

Used when in prompted mode for displaying the complete

configuration table from the beginning.

Exit Configuration (Z)

To exit configuration in both permanent change and temporary

change mode.

Activating the changes

After making changes to the configuration and exit from the

configuration menu, it is necessary to action the new parameters in

the non-volatile memory. This can be done in one of three ways:

Press the RESET button,

Turn the mains power off, then back on,

Send the command <ESC><ESC>! to the unit.

In all cases (except if Automatic Reset option is enabled) the unit will

initialise and send the R: ENTER RESET message to the Host. The unit

is then brought back on line by sending ESC A. If speed changes are

made, these are functional from the start of the output of the R:

ENTER RESET message.

5. LED DISPLAY

The 5 LED's on the Telex Unit front panel provide a visual indication of

the operational state of the unit. Typical examples are,

all LED's off for longer than 5 seconds; no power

all LED's on;

Tx or Rx flashing (Host or Telex);

Any queries regarding the correct operation of the Telex Unit should

be referred to the Host equipment supplier.

Reset command required.

indication of data transfer in

progress on Host or Telex

side.