Andonstar AD407 사용자 설명서 - 페이지 6

{카테고리_이름} Andonstar AD407에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Andonstar AD407 14 페이지.
Andonstar AD407에 대해서도 마찬가지입니다: 사용자 설명서 (11 페이지)

(P2, Assembly1)

(P3, Assembly2)

Assembly

1. Screw the optical bracket on to the base (see the left picture above,P2 ).

2. Once you have done so, if the bracket is not aligned over the base, unscrew the locking ring, adjust the

bracket's

direction,

and

then

turn

the

locking

ring

clockwise

until

tight.

(After doing so, it will still be possible to hold the base and

turn the bracket if sufficient force is applied, but it will not spin freely.)

3. Loosen the small thumbscrews on the optical bracket.

4. Slide the optical stack in to the ring of the optical bracket.

5. Tighten the thumbscrews to hold the optical stack in place.

If done correctly, you should be able to not just turn the focus controller of the optical stack freely, but also

freely adjust the monitor, the angel between the base and the optical bracket, while the rest of

microscope remains in place. If you have any question or problem for assembly, please contact us as soon

as possible, so you won't damage the device during assembly.