Andover Controls EMX34/CK34 설치 매뉴얼 - 페이지 9

{카테고리_이름} Andover Controls EMX34/CK34에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andover Controls EMX34/CK34 12 페이지. Cardkey interface board

Wiring the Cardkey Reader to the EMX 34 Interface Board

Each Cardkey input on the EMX34 takes 6 wires. There are four inputs, located along the

right-hand side of the printed circuit board (P2, P4, P6, and P8).

1. Locate the existing gray cable on the back side of the Cardkey reader. Strip the end

of the cable to expose the wires.

2. Strip the ends of the black, white and red wires.

3. Following the wiring diagram below, place the appropriate wires into the correct

terminals and tighten the screws. Insert the shield into the GND terminal.

Wiring the EMX 34 to the Cardkey Reader and LEDs

EMX 34 PCB

(6)

(5)

(4)

(3)

(2)

(1)

Technical Manuals Online! - http://www.tech-man.com

5VDC

LED

PWR

Black

RED

Red

LED

White

GREEN

Shield

LED

DATA

GND

5VDC

existing cable (for reader)

LED

PWR

RED

extra cable (for LEDs)

Cardkey Reader

Red

White

Black

Shield

Molex

Connector

EMX 34 Installation Guide