Electrolux DF 6260 운영 및 설치 매뉴얼 - 페이지 16

{카테고리_이름} Electrolux DF 6260에 대한 운영 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux DF 6260 20 페이지. Cooker hood
Electrolux DF 6260에 대해서도 마찬가지입니다: 작동 및 설치 지침 (22 페이지)

페이지 인쇄

• If the cupboard is deeper than 300 mm, cover the gap between the

hood and the wall with a finishing strip (special accessory).

To install it, proceed as follows:

Measure the wall distance and apply the covenng strip over the

necessary width (wall distance plus 5 to 8 mm), kinking the covering

strip at the appropriate notches and tearing off the surplus material

(removing the protective foil).

Then fasten the strip to the bottom part of the hood with three clips

(special accessories). Apply pressure. Fig. 12.

Fig. 12

Fitting the charcoal filter for recirculation version

If the extractor hood is installed as a return air appliance (Recirculation

version - air outlet above the wall unit), the charcoal filter (available

from

your local Service Force Centre) must be fitted before the grease

filters are fitted.

Installation sequence:

1. Insert the holding frame for the charcoal filter in the shaft of the

hood with the 2 lugs facing upwards and then clip into the lower

holes.

2. Fix the holding frame on the lower part of the housing of the hood

with the 2 screws supplied. Fig. 13.

3. Fit the charcoal filter (see paragraph "Charcoal filter")

4. Refit the grease filters. Push-in the visor.

Fig. 13