Atlantic PV1700 제품 설명서 - 페이지 10

{카테고리_이름} Atlantic PV1700에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic PV1700 12 페이지. Oasis series skimmer, filterfalls, pump vault, fastfalls
Atlantic PV1700에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지)

페이지 인쇄

Use a small piece of sandpaper to smooth out the cut end of the

discharge pipe. Clean the 2" socket fitting on the bottom of the check

valve and the cut end of the discharge pipe with PVC cleaner/primer.

Apply PVC glue and insert the discharge pipe into the 2" socket fitting.

Hold the discharge pipe firmly in place for a few seconds, giving the

glue time to set.

Attach the Triton Check Valve to the TidalWave pump by threading the

discharge pipe into the pump discharge.

Place the TidalWave pump with installed Triton Check Valve into the

Pump Vault. Connect the outlet fitting of the Triton Check Valve to the

PVC supply line that feeds the waterfall using PVC glue and cleaner. For

your convenience; 2" and 1½" outlet fittings are supplied with the Triton

Check Valve.

Complete installation by hand tightening the union nuts on the Triton

Check Valve. Do not over tighten. For more detailed instructions, refer to

the instruction booklet included with the check valve.

AF1000 AUTO FILL KIT

Drill points or flat areas have been provided for the proper Auto Fill location on either side

of the Pump Vault. It is a good idea to completely install the pump, check valve assembly,

and discharge hose before you drill for the Auto Fill. This will help you determine the best

side of the Skimmer or Pump Vault to place the Auto Fill so that it has proper clearance on

all sides. The center point of the Auto Fill should be located approximately 1½ to 2" above

the normal operating water level of the basin.

Once you have determined the location of the Auto Fill, drill a ⅞" hole using a spade bit or

hole saw. Insert the Auto Fill, making sure the gasket is on the water side of the unit, and

the plastic retaining nut is on the outside. Thread the retaining nut onto the Auto Fill Valve,

being careful not to over-tighten.

AUTO-FILL

VALVE

The Auto Fill Kit includes fittings for connection to a garden hose, ½" irrigation line, and ½"

Sch 40 PVC. Wrap the ½" male threads on the Auto Fill with thread sealant and install the

fitting of your choice. Once water is supplied to the Auto Fill it will maintain the set water

level by automatically adding water when the level drops. This level can be adjusted by

loosening the wing nut and raising and lowering the height of the Auto Fill float.

Flow Rate: 0.5 to 1.5 gpm / Inlet Pressure: 80 psi max

GASKET

WING NUT

WATER LEVEL

OUTLET

FITTING

RETAINING

NUT