Atlantic Ultraviolet 10-0518A 설치 운영 및 유지보수 - 페이지 11

{카테고리_이름} Atlantic Ultraviolet 10-0518A에 대한 설치 운영 및 유지보수을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlantic Ultraviolet 10-0518A 16 페이지. Ultraviolet water purifiers

UARTZ

LEEVE

NSTALLATION

Step 4 - Remove Gland Nut From Each End

SAFETY EQUIPMENT REQUIRED TO PERFORM TASK

WARNING: Disconnect power to water purifier.

•

For 120v 50/60Hz version using ballast no. 10-0518A or 230v 50/60hz version using ballast no. 10-0514A, remove

the ground connector from the chamber, and go to the next step.

Shut off water supply to water purifier via inlet and outlet shut off valves and drain chamber, if possible.

3. Follow the steps in "Lamp Installation or Replacement" to remove lamp.

CAUTION: Lamp and quartz sleeve are easily damaged. Exercise care when handling.

Unscrew static gland nuts from each end of the chamber. Avoid striking quartz sleeve with static gland nut.

Remove Teflon

washer and o-ring from both ends of quartz sleeve. Teflon

gland nut. If so, remove Teflon

6. Carefully remove quartz sleeve from chamber. NOTE: It is advisable to support the quartz sleeve on the opposite end

with your finger so that it does not drop to the bottom of the chamber as it slides into the chamber.

7. Once the quartz sleeve is removed, clean with alcohol or a mild, non-abrasive detergent. Stubborn stains usually can be

removed with a dilute hydrochloric acid. NOTE: Follow all manufacturer's instructions and precautions

when handling chemicals.

Reassemble in reverse order. Make sure the quartz sleeve protrudes an equal distance past each threaded nipple. Be sure

o-rings are placed on quartz sleeve before Teflon

9. Tighten static gland nuts firmly by hand only, DO NOT USE HAND TOOLS. Tightening with hand tools is likely to cause

quartz sleeve to break.

10. Slowly restore water supply to water purifier and check for leaks.

11. If no leaks occur, reinstall lamp, following the steps in "Lamp Installation or Replacement" section.

WARNING: Germicidal ultraviolet rays are harmful to eyes and skin. Do not restore power to water purifier until

lamps and both EASY-OFF

, C

LEANING OR

Figure 5 - BIO-1.5 & BIO-3.0 120v 50/60Hz

(ballast no. 10-0518A)

Step 5 - Remove Washer & O-Ring

from each end

washer from static gland nut before proceeding.

washer.

end caps have been properly reinstalled.

EPLACEMENT

washer will sometimes remain within the static

Step 6 - Remove Quartz Sleeve