Electrolux central vacuum systems 설치 매뉴얼 - 페이지 10

{카테고리_이름} Electrolux central vacuum systems에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux central vacuum systems 11 페이지. Central vacuum systems

Electrolux central vacuum systems 설치 매뉴얼
10
electrolux installation manual

Electrical Connection-

Low-Voltage Cable
To power on the central vacuum system, a 24V low-voltage cable is
routed to each inlet valve. Parallel connection is made according to the
figure below.
inlet vavles conneted
inlet valve1
in series
inlet valve 2
low voltage circuit diagram
low voltage cable
with stripped ends
contact pins
low voltage
cable
inlet valve
It is recommended that the low-voltage cable be installed in a conduit
pipe, and this is absolutely necessary when cables are to be hidden in
cast concrete. If the cable becomes defective, it is also much easier
to change it afterwards. In these installations, only certified electrical
components may be used.
The power unit is connected to an electrical outlet. If there is no outlet
nearby, an electrician will carry out installation.
All the high-voltage connections are under the turbine cover. Only an
electrician is allowed to open the cover.
low voltage
cable
inlet valve 3
low voltage
connetion terminals