Electrolux central vacuum systems 설치 매뉴얼 - 페이지 4

{카테고리_이름} Electrolux central vacuum systems에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Electrolux central vacuum systems 11 페이지. Central vacuum systems

electrolux installation manual

Installation of the Wall Inlet Valves

For the installation, you will usually need the following parts:

Mounting bracket

Inlet valve

Wall Installation of the Inlet Valve

A typical wall inlet valve installation is shown in the figure on the right.

A 90° inlet elbow is used in the wall installation to prevent long objects

entering into the tubing system, protecting it against blockages.

A 90° steep elbow can be fitted in two different ways. In practice, the

partition wall can be as narrow as 2 3/4" (65mm).

Note! A 90° inlet elbow must not be installed anywhere else in the tubing

system.

If the thickness of the wall board is more than 1" (25mm), you can reach

the mounting bracket by using an extension tube.

seal

Note! When installing the short version of the 90° inlet elbow, use

short screws so that they do not extend into the tube.

90° elbow

low voltage cable

90° elbow

min. 2 3/4"

(65 mm)

mounting bracket

choose the best angle

of the 90 ° inlet elbow

so that it fits best in

the surrounding space

open cavity

90° sweep elbow

If the Structures of the House Prevent Tubing Routing

This can be avoided by making slots as shown in the figure below.

Supporting structural elements of the house should not be slotted. If you

cannot attach the mounting bracket properly to the batten wall, you can

install a separate mounting board.

mounting board

mounting bracket

sweep elbow

inlet valve

floor