Atlas CP700 사양 시트 - 페이지 2
{카테고리_이름} Atlas CP700에 대한 사양 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas CP700 2 페이지. Commercial dual channel power amplifiers
Atlas CP700에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (16 페이지), 브로셔 및 사양 (10 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (16 페이지)
페이지 인쇄
SPECIFICATIONS
DIRECT POWER OUTPUTS
Max Average Power @ 35Hz-20kHz with 0.1% THD
(10-80k Filter)
8 Ohm, 30Hz-20KHz, 0.1% THD
8 Ohm, 1kHz, 0.1% THD
4 Ohm, 1kHz, 0.1% THD
2 Ohm, 1kHz, 0.1% THD
Bridged Mono 8 Ohm
1kHz, 1% THD
Bridged Mono 4 Ohm
1kHz, 1% THD
TRANSFORMER OUTPUTS
25V
70V
100V
140V Bridged
200V Bridged
FREQUENCY RESPONSE
Direct Outputs (+0/-3dB)
Transformer Outputs (+0/-3dB)
THD+N
8 Ohm, 1kHz, 240W per channel
SENSITIVITY
Rated Ouput into 8 Ohms
VOLTAGE GAIN
32dB
INPUT IMPEDANCE
Balanced/Unbalanced
DAMPING FACTOR
8 Ohms Output, 10 Vrms
S/N RATIO
8 Ohms per Channel @ 240W
The amplifier shall be Atlas Sound CP700 Commercial Audio Amplifier.
The power amplifier shall have two channels. At 8 Ohms, 30Hz-
20kHz, it shall deliver 240 Watts per channel. At 4 Ohms, 1kHz, it shall
deliver 400 Watts per channel. At 2 Ohms, 1kHz, it shall deliver 550
Watts per channel. In bridge mono mode, with an 8 Ohm load, it shall
deliver 850 Watts. In bridge mono mode, with a 4 Ohm load, it shall
deliver 1100 Watts. The amplifier shall have internal circuits to protect
itself from output short circuits and thermal overload and will protect
attached loudspeakers from amplifier failure and DC voltages.
1601 JACK MCKAY BLVD. / ENNIS, TEXAS 75119 U.S.A.
TELEPHONE: (800) 876-3333 / FAX (800) 765-3435
© 2005 Atlas Sound LP
PROTECTION CIRCUITS
Output Offset Voltage Protection
Heat Sink Overheat Protection
240W x 2
Transformer Overheat Protection
300W X 2
Load Shorting Protection
400W X 2
Soft Clip Limiters
550W X 2
850W
1100W
CONTROLS
280W X 2
Power Switch, Ch 1/Ch 2 gain (41 step)
350W X 2
Parallel/Stereo/Bridge Switch
350W X 2
700W
700W
COOLING
30Hz-50kHz
Dual Speed Fan, Temperature Controlled
30Hz-16kHz
INDICATORS
<.05%
Power, Protect, Signal, Limit
DIMENSIONS
1.25V
132mm X 480mm X 428mm (5.19" X 18.9" X 16.85")
NET WEIGHT
24.3kg (54 lbs)
SHIPPING WEIGHT
20k/10k Ohm
26kg (57 lbs)
>200dB
100dB
ARCHITECT & ENGINEER SPECIFICATIONS
Specifications subject to change without notice
Printed in U.S.A.
A variable speed fan shall provide heat sink cooling. Each channel to
have an input sensitivity of 1.25V, frequency response shall be 30Hz-
50kHz +0/-3dB direct mode and 30Hz-16kHz +0/-3dB in transformer
mode. Front panel indicators to include signal present, limiter, and
protection LEDs. Rear mounted stepped attenuators to provide
repeatability of gain settings. Input terminations shall be balanced
on barrier strip terminals or XLR female connectors. Loudspeaker
outputs shall be of the barrier strip type. A switch on the rear panel to
provide selection of Stereo, Parallel, and Bridge Modes of operation.
Dimensions shall be 5.19" X 18.9" X 16.85" and the amplifier shall
weigh 57 lbs.
AtlasSound.com
001105
ATS002228 RevA 11/05
SL9-2076