Atlas DPA-102PM 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Atlas DPA-102PM에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas DPA-102PM 20 페이지. Networkable 2-channel power amplifier with dsp

DPA-102PM - Networkable 2-Channel

Power Amplifier with DSP

DPA-102PM Pole Mount – Chassis Side

1. Make sure the pole does not exceed 2" or 51mm. Common pipe for video projector mounting is 1.5" ID plumbing pipe. The OD for

this pipe is 1.9" or 49mm.

2. Make sure the DPA-102PM is unplugged from the AC source.

3. Remove the top hole plug.

4. Secure the pole support bracket using the four screws as shown in the diagram below. Note: the support bracket can only be

installed on the top or bottom of the amplifier.

5. Slide the "U" clamp around the pole and into the bracket slots. Do not force the amp onto the pole. Pay attention to orientation of

the amp.

6. Secure the "U" clamp by adding the washers and nuts to the U Bolt. Clamp the amp onto the pole by tightening the two nuts until

the amp is secure in place. Do not over tighten.

7. DO NOT mount any additional amplifiers to the same bracket. The support bracket is designed to support only one DPA-102PM.

Rack Mount – Optional Accessory Kit

The DPA-102PM can be rack mounted as shown below using the optional rack mount kit, model PA702-RMK.

AtlasSound.com

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 10 –

Specifications are subject to change without notice.

Owner's Manual